Fcdomain Rcf-Reject - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

fcdomain rcf-reject

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
fcdomain rcf-reject
To enable the RCF reject flag for a Fibre Channel interface, use the fcdomain option. To disable this
feature, use the no form of the command.
Syntax Description
vsan vsan-id
Command Default Enabled.
Command Modes Interface configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines Use this option to configure the RCF reject option for the selected Fibre Channel or virtual Fibre Channel
interface.
Examples The following example shows how to configure the FCIP RCF reject fcdomain feature on a virtual Fibre
Channel interface:
switch(config)# interface vfc 3
switch(config-if)# fcdomain rcf-reject vsan 1
Related Commands Command
show fcdomain
show interface fc
Cisco Nexus 5000 Series Command Reference
8-52
fcdomain rcf-reject vsan vsan-id
no fcdomain rcf-reject vsan vsan-id
Specifies a VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays global information about the Fibre Channel domain configurations.
Displays an interface configuration for a specified Fibre Channel interface.
Chapter 8 Fibre Channel Commands
OL-16599-01