Interface San-Port-Channel - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

interface san-port-channel

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
interface san-port-channel
To configure a SAN port channel interface on a Cisco Nexus 5000 Series switch, use the interface
san-port-channel command. The interface san-port-channel command enters interface configuration
mode, which includes six commands (each with a no form).
To revert to defaults, use the no form of the command.
Syntax Description port
description line
shutdown
force
switchport
Command Default Disabled.
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines Use the no shutdown command to enable the interface.
Cisco Nexus 5000 Series Command Reference
8-92
interface san-port-channel port
description line
shutdown [force]
switchport {
mode { E | auto} |
speed { 1000 | 2000 | 4000 | auto} |
trunk { allowed vsan {vsan-id | add vsan-id | all} | mode {auto | on | off}}
}
no interface san-port-channel port
no description
no shutdown
no switchport {
no mode |
no speed |
no trunk { allowed vsan { vsan-id | add vsan-id | all}| mode }
Specifies a port number.
Enters a line of text to describe the interface.
Changes the interface state to administrative down.
Forces the interface state to administrative down.
Enters configuration parameters for the SAN port channel .
Modification
This command was introduced.
Chapter 8 Fibre Channel Commands
OL-16599-01