Port-Security Enable - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 8 Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

port-security enable

To enable port security, use the port-security enable command. To disable port security, use the no form
of the command.
Syntax Description
This command has no other arguments or keywords.
Command Default Disabled.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines Entering the port-security enable command enables the other commands that are used to configure port
security.
Examples The following example shows how to enable port security:
switch(config)# port-security enable
The following example shows how to disable port security:
switch(config)# no port-security enable
Related Commands Command
show port-security
OL-16599-01
port-security enable
no port-security enable
Modification
This command was introduced.
Description
Displays port security information.
Cisco Nexus 5000 Series Command Reference
port-security enable
8-115