Member (Zoneset Configuration Mode) - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 8 Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

member (zoneset configuration mode)

To configure zone set members, use the member command in zone set configuration mode. To remove
a zone set member, use the no form of the command.
Syntax Description
member-name
Command Default None
Command Modes Zone set configuration mode
Command History Release
4.0(0)N1(1a)
Examples The following example shows how to add a member zone to a zone set:
switch(config)# zoneset name Zoneset1 vsan 10
switch(config-zoneset)# member ZoneA
Related Commands Command
show zone
zoneset name
OL-16599-01
member member-name
no member member-name
Specifies the member name. Maximum length is 64 characters.
Modification
This command was introduced.
Description
Displays zone information.
Creates a zone set.
member (zoneset configuration mode)
Cisco Nexus 5000 Series Command Reference
8-103