Show Policy-Map Interface - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 5 Quality of Service Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

show policy-map interface

To display policy maps and statistics for the interfaces, use the show policy-map interface command.
Syntax Description ethernet
slot/port
port-channel
channel-number
input
output
type
qos
queuing
Defaults None.
Command Modes Any command mode
Command History Release
4.1(3)N1(1)
Usage Guidelines Statistics are on by default.
This command does not require a license.
Examples
This example shows how to display policy maps assigned to a specified interface:
switch(config)# show policy-map interface ethernet 2/10
switch(config)# show policy-map interface ethernet 2/2 type qos
Related Commands Command
class-map
OL-16599-01
show policy-map interface [ethernet {slot/port} | port-channel {channel-number}] [input |
output] [type {qos | queuing}]
(Optional) Displays policy maps assigned to Ethernet interfaces.
Displays policy maps assigned to specified interface.
(Optional) Displays policy maps assigned to port channels.
Displays policy maps assigned to specified port channel.
(Optional) Displays policy maps assigned to input traffic only.
(Optional) Displays policy maps assigned to output traffic only.
(Optional) Specifies the component type to display.
Displays policy maps of type qos only.
Displays policy maps of type queuing only.
Modification
This command was introduced.
Description
Creates or modifies a class map.
show policy-map interface
Cisco Nexus 5000 Series Command Reference
5-23