Spanning-Tree Mst Hello-Time - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

spanning-tree mst hello-time

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
spanning-tree mst hello-time
To set the hello-time delay timer for all the instances on the switch, use the spanning-tree mst hello-time
command. To return to the default settings, use the no form of this command.
Syntax Description
seconds
Command Default
2 seconds.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines If you do not specify the hello-time value, the value is calculated from the network diameter.
Examples This example shows how to set the hello-time delay timer:
switch(config)# spanning-tree mst hello-time 3
Related Commands Command
show spanning-tree
mst
Cisco Nexus 5000 Series Command Reference
2-62
spanning-tree mst hello-time seconds
no spanning-tree mst hello-time
Number of seconds to set the hello-time delay timer for all the instances on
the switch; the range of valid values is from 1 to 10 seconds.
Modification
This command was introduced.
Description
Displays the information about the MST protocol.
Chapter 2 Ethernet Commands
OL-16599-01