Npv Enable - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

npv enable

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
npv enable
To enable N Port Virtualization (NPV) mode, use the npv enable command. To disable this feature, use
the no form of the command.
Syntax Description
This command has no other arguments or keywords.
Command Default None
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines When NPV mode is enabled, switch configuration related to interfaces is erased and the switch is
rebooted. The switch restarts in NPV mode. Configuration and verification commands for NPV are
available only when NPV is enabled on the switch. When you disable NPV mode, all related
configurations are automatically erased and the switch is rebooted.
Examples
The following example shows how to enable NPV mode:
switch(config)# npv enable
Related Commands Command
show npv status
Cisco Nexus 5000 Series Command Reference
8-106
npv enable
no npv enable
Modification
This command was introduced.
Description
Displays the NPV current status.
Chapter 8 Fibre Channel Commands
OL-16599-01