Port-Track Force-Shut - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 8 Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

port-track force-shut

To force a shutdown of a tracked port, use the port-track force-shut command. To reenable the port
tracking, use the no form of the command.
Syntax Description
This command has no other arguments or keywords.
Command Default None
Command Modes Interface configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines Use the port-track force-shut command to keep the linked port down, even though the tracked port
comes back up. You must explicitly bring the port up when required using the no port-track force-shut
command.
Examples
The following example shows how to force the shutdown of an interface and the interfaces that it is
tracking:
switch(config)# interface fc 2/2
switch(config-if)# no port-track force-shut
Related Commands Command
port-track enable
show interface fc
show interface
san-port-channel
OL-16599-01
port-track force-shut
no port-track force-shut
Modification
This command was introduced.
Description
Enables port tracking.
Displays configuration and status information for a specified Fibre Channel
interface.
Displays configuration and status information for a specified SAN port
channel interface.
Cisco Nexus 5000 Series Command Reference
port-track force-shut
8-117