Match Ip Rtp - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 5 Quality of Service Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

match ip rtp

To configure a class map to use the Real-Time Protocol (RTP) port as a match criteria, use the match ip
rtp command. To remove the RTP port as a match criteria, use the no form of this command.
Syntax Description
not
port-list
Defaults None
Command Modes Class-map type qos configuration
Command History Release
4.1(3)N1(1)
Usage Guidelines To specify a list of values, use one of the following options:
•
•
This command does not require a license.
Examples
This example shows how to match on a port using RTP:
switch(config)# class-map my_test
switch(config-cmap-qos)# match ip rtp 2300
Related Commands Command
show class-map
OL-16599-01
match [not] ip rtp port-list
no match [not] ip rtp port-list
(Optional) Negates the specified match result.
Matches on the specified UDP or list of UDP ports that are using RTP.
Valid values range from 2000 to 65535.
Modification
This command was introduced.
Specify a range of values separated by a dash
Specify a noncontiguous list of values separated by commas
Description
Displays class maps.
Cisco Nexus 5000 Series Command Reference
match ip rtp
5-11