Logging Fex - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

logging fex

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
logging fex
To set the logging alert level for Fabric Extender events, use the logging fex command. To reset the
logging level, use the no form of this command.
Syntax Description
severity-level
Command Default None
Command Modes
Configuration mode
Command History Release
4.0(1a)N2(1)
Examples This example shows how to set the logging alert level for Fabric Extender events:
switch(config)# logging fex 4
This example shows how to reset the logging level:
switch(config)# no logging fex
Related Commands Command
show fex
Cisco Nexus 5000 Series Command Reference
4-8
logging fex [severity-level]
no logging fex [severity-level]
(Optional) Number of the desired severity level at which messages should be logged.
Messages at or numerically lower than the specified level are logged. Severity levels
are as follows:
0—emergency: System unusable
•
• 1—alert: Immediate action needed
• 2—critical: Critical condition—default level
• 3—error: Error condition
• 4—warning: Warning condition
5—notification: Normal but significant condition
•
6—informational: Informational message only
•
7—debugging: Appears during debugging only
•
Modification
This command was introduced.
Description
Displays all configured Fabric Extender chassis connected to the switch.
Chapter 4 Fabric Extender Commands
OL-16599-01