Feature Private-Vlan - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 1 Basic System Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

feature private-vlan

To enable private VLANs, use the feature private-vlan command. To return to the default settings, use
the no form of this command.
Syntax Description
None
Command Default Private VLANs are disabled.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines The private VLAN commands are not available until you enable the private VLAN feature.
You cannot disable the private VLANs if there are operational ports on the switch that are in private
VLAN mode.
A PVLAN isolated port on a Cisco Nexus 5000 Series switch running the current release of Cisco
Note
NX-OS does not support IEEE 802.1q encapsulation and cannot be used as a trunk port.
Examples
This example shows how to enable private VLAN functionality on the switch:
switch(config)# feature private-vlan
Related Commands Command
private-vlan
show vlan private-vlan Displays information on private VLANs. If the feature is not enabled, this
OL-16599-01
feature private-vlan
no feature private-vlan
Modification
This command was introduced.
Description
Configures a VLAN as either a community, isolated, or primary private
VLAN.
command is not available.
Cisco Nexus 5000 Series Command Reference
feature private-vlan
1-41