Zone Name (Zone Set Configuration Mode) - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

zone name (zone set configuration mode)

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
zone name (zone set configuration mode)
To configure a zone in a zone set, use the zone name command in zone set configuration mode. To delete
the zone from the zone set, use the no form of the command.
Syntax Description
zone-name
Command Default None
Command Modes Zone set configuration mode
Command History Release
4.0(0)N1(1a)
Examples The following example configure a zone in a zone set:
switch(config)# zoneset name Sample vsan 1
switch(config-zoneset)# zone name MyZone
The following example deletes a zone from a zone set:
switch(config-zoneset)# no zone name Zone2
Related Commands Command
show zoneset
zone name
(configuration mode)
zoneset
Cisco Nexus 5000 Series Command Reference
8-154
zone name zone-name
no zone name zone-name
Specifies the name of the zone. Maximum length is 64 characters.
Modification
This command was introduced.
Description
Displays zone set information.
Configure zones.
Configures zone set attributes.
Chapter 8 Fibre Channel Commands
OL-16599-01