Logging Level - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

logging level

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
logging level
Use the logging level command to enable logging messages from the defined facility that have the
specified severity level or higher.
To disable logging messages from the defined facility, use the no form of this command.
Syntax Description
facility
severity-level
Command Default None
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Examples
This example shows how to enable logging messages from the AAA facility that have a severity level of
2 or higher:
switch(config)# logging level aaa 2
Cisco Nexus 5000 Series Command Reference
7-10
logging level facility severity-level
no logging level facility severity-level
Defines the appropriate facility. The facilities are listed in the
Message Logging Facilities" section on page
To apply the same severity level to all facilities, use the all facility.
The number of the desired severity level at which messages should be
logged. Messages at or numerically lower than the specified level are logged.
Severity levels are as follows:
•
•
•
•
•
•
•
•
Modification
This command was introduced.
0—emergency: System unusable
1—alert: Immediate action needed
2—critical: Critical condition—default level
3—error: Error condition
4—warning: Warning condition
5—notification: Normal but significant condition
6—informational: Informational message only
7—debugging: Appears during debugging only
Chapter 7 System Management Commands
"System
45.
OL-16599-01