Ipv6 Port Traffic-Filter - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 6 Security Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

ipv6 port traffic-filter

To apply an IPv6 access control list (ACL) to an interface as a port ACL, use the ipv6 port traffic-filter
command. To remove an IPv6 ACL from an interface, use the no form of this command.
Syntax Description
access-list-name
in
Command Default None
Command Modes Interface configuration mode
Command History Release
4.0(1a)N1(1)
Usage Guidelines By default, no IPv6 ACLs are applied to an interface.
You can use the ipv6 port traffic-filter command to apply an IPv6 ACL as a port ACL to the following
interface types:
•
•
You can also use the ipv6 port traffic-filter command to apply an IPv6 ACL as a port ACL to the
following interface types:
•
You must enable VLAN interfaces globally before you can configure a VLAN interface. For more
Note
information, see the
The switch applies port ACLs to inbound traffic only. The switch checks inbound packets against the
rules in the ACL. If the first matching rule permits the packet, the switch continues to process the packet.
If the first matching rule denies the packet, the switch drops the packet and returns an ICMP
host-unreachable message.
If you delete the specified ACL from the device without removing the ACL from an interface, the deleted
ACL does not affect traffic on the interface.
OL-16599-01
ipv6 port traffic-filter access-list-name in
no ipv6 port traffic-filter access-list-name in
Name of the IPv6 ACL, which can be up to 64 alphanumeric, case-sensitive
characters.
Specifies that the device applies the ACL to inbound traffic.
Modification
This command was introduced.
Ethernet interfaces
EtherChannel interfaces
VLAN interfaces
feature interface-vlan command.
Cisco Nexus 5000 Series Command Reference
ipv6 port traffic-filter
6-45