fspf hello-interval
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
fspf hello-interval
To verify the health of the link, use the fspf hello-interval command. To revert to the default value, use
the no form of the command.
Syntax Description
hello-interval seconds
vsan vsan-id
Command Default
20 seconds.
Command Modes
Interface configuration mode
Command History
Release
4.0(0)N1(1a)
Usage Guidelines
This command is not applicable to virtual Fibre Channel interfaces.
This command configures FSPF for the specified Fibre Channel interface. This value must be the same
in the ports at both ends of the ISL.
Examples
The following example configures a hello interval of 3 seconds on VSAN 1:
switch(config)# interface fc 2/1
switch(config-if)# fspf hello-interval 3 vsan 1
Related Commands
Command
show fspf interface
Cisco Nexus 5000 Series Command Reference
8-86
fspf hello-interval seconds vsan vsan-id
no fspf hello-interval seconds vsan vsan-id
Specifies the FSPF hello-interval in seconds. The range is 2 to 65535.
Specifies a VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays information for each selected interface.
Chapter 8
Fibre Channel Commands
OL-16599-01