Spanning-Tree Port Type Edge Bpduguard Default - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

spanning-tree port type edge bpduguard default

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
spanning-tree port type edge bpduguard default
To enable BPDU Guard by default on all spanning tree edge ports, use the spanning-tree port type edge
bpduguard default command. To disable BPDU Guard on all edge ports by default, use the no form of
this command.
Syntax Description
This command has no keywords or arguments.
Command Default
Disabled.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines
To enable BPDU Guard by default, you must do the following:
•
•
Use this command to enable BPDU Guard globally on all spanning tree edge ports. BPDU Guard disables
a port if it receives a BPDU.
Global BPDU Guard is applied only on spanning tree edge ports.
You can also enable BPDU Guard per interface; see
information.
We recommend that you enable BPDU Guard on all spanning tree edge ports.
Note
Examples
This example shows how to enable BPDU Guard by default on all spanning tree edge ports:
switch(config)# spanning-tree port type edge bpduguard default
Cisco Nexus 5000 Series Command Reference
2-78
spanning-tree port type edge bpduguard default
no spanning-tree port type edge bpduguard default
Modification
This command was introduced.
Configure the interface as spanning tree edge ports by entering the
or the spanning-tree port type edge default
Enable BPDU Guard.
Chapter 2
spanning-tree port type edge
command.
spanning-tree bpduguard
Ethernet Commands
command for more
OL-16599-01