Terminal Terminal-Type - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

terminal terminal-type

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
terminal terminal-type
To set the terminal type for the current session, use the terminal terminal-type command. To revert to
the default, use the no form of this command.
Syntax Description
type
Command Default
For a virtual terminal, the terminal type is set during negotiation with the client software. Otherwise,
vt100 is the default.
Command Modes EXEC mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines
The terminal type setting applies only to the current session.
Examples This example shows how to set the terminal type:
switch# terminal type xterm
This example shows how to revert to the default terminal type:
switch# terminal no type
Related Commands Command
show terminal
Cisco Nexus 5000 Series Command Reference
1-120
terminal terminal-type type
terminal no terminal-type
Type of terminal. The type string is case sensitive, must be a valid type (for
example, ansi, vt100, or xterm), and has a maximum of 80 characters.
Modification
This command was introduced.
Description
Displays the terminal session configuration.
Chapter 1 Basic System Commands
OL-16599-01