Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 639

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

Fibre Channel Commands

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

Command History

4.0(0)N1(1a)

Usage Guidelines

You can specify a range of interfaces by entering a command with the following example format:

interface fc 1/1 - 5 , fc 2/5 - 7

Refer to the Cisco Nexus 5000 Series CLI Configuration Guide for information on port number

Use the no shutdown command to enable the interface.

The channel-group auto command enables autocreation of port channels. If autocreation of port

channels is enabled for an interface, you must first disable this configuration before downgrading to

earlier software versions or before configuring the interface in a manually configured channel group.

The following example configures ports 1 to 4 in Fibre Channel interface 3:

switch(config)# interface fc 3/1 - 4

The following example enables the Fibre Channel interface in port 1 of slot 3:

switch(config)# interface fc 3/1

switch(config-if)# no shutdown

Related Commands

show interface

Modification

This command was introduced.

Displays an interface configuration for a specified interface.

Disables and enables an interface.

Cisco Nexus 5000 Series Command Reference

interface fc