Cfs Ipv6 Mcast-Address - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

Chapter 8
Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

cfs ipv6 mcast-address

To configure an IPv6 multicast address for Cisco Fabric Services (CFS) distribution over IPv6, use the
cfs ipv6 mcast-address command. To disable this feature, use the no form of the command.
Syntax Description
ipv6-address
Command Default
Multicast address: ff15::efff:4653.
Command Modes
Configuration mode
Command History
Release
4.0(0)N1(1a)
Usage Guidelines
Before using this command, enable CFS distribution over IPv6 using the cfs ipv6 distribute command.
All CFS over IP enabled switches with similar multicast addresses form one CFS over IP fabric. CFS
protocol-specific distributions, such as the keepalive mechanism for detecting network topology
changes, use the IP multicast address to send and receive information. CFS distributions for application
data use directed unicast.
You can configure a CFS over IP multicast address value for IPv6. The default IPv6 multicast address is
ff15::efff:4653. Examples of the IPv6 Admin scope range are ff15::0000:0000 to ff15::ffff:ffff and
ff18::0000:0000 to ff18::ffff:ffff.
Examples
The following example shows how to configure an IP multicast address for CFS over IPv6:
switch(config)# cfs ipv6 mcast-address ff13::e244:4754
Distribution over this IP type will be affected
Change multicast address for CFS-IP ?
Are you sure? (y/n) [n] y
The following example shows how to revert to the default IPv6 multicast address for CFS distribution
over IPv6:
switch(config)# no cfs ipv6 ff13::e244:4754
Distribution over this IP type will be affected
Change multicast address for CFS-IP ?
Are you sure? (y/n) [n] y
OL-16599-01
cfs ipv6 mcast-address ipv6-address
no cfs ipv6 mcast-address ipv6-address
Specifies an IPv6 multicast address or CFS distribution over IPv6. The IPv6
Admin scope range is [ff15::/16, ff18::/16].
Modification
This command was introduced.
Cisco Nexus 5000 Series Command Reference
cfs ipv6 mcast-address
8-9

Advertisement

Table of Contents
loading

Table of Contents