System Default Zone Default-Zone Permit - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 8 Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

system default zone default-zone permit

To configure default values for a zone, use the system default zone default-zone permit command. To
revert to the defaults, use the no form of the command.
Syntax Description
This command has no arguments or keywords.
Command Default No default values for zones.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines This command defines the default values for the default zone for all VSANs. The default values are used
when you initially create a VSAN and it becomes active. If you do not want to use the default values,
use the zone default-zone permit vsan command to define the operational values for the default zone.
The system default zone default-zone permit command should only be used in conjunction with
VSANs that have not yet been created; it has no effect on existing VSANs.
Because VSAN 1 is the default VSAN and is always present, this command has no effect on it.
Examples
The following example sets the default zone to use the default values:
switch(config)# system default zone default-zone permit
The following example restores the default setting:
switch(config)# no system default zone default-zone permit
Related Commands Command
zone default-zone
permit vsan
show system default
zone
OL-16599-01
system default zone default-zone permit
no system default zone default-zone permit
Modification
This command was introduced.
Description
Defines whether a default zone (nodes not assigned a created zone) permits
or denies access to all in the default zone.
Displays default values for the default zone.
system default zone default-zone permit
Cisco Nexus 5000 Series Command Reference
8-137