Revision - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

revision

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
revision
To set the revision number for the Multiple Spanning Tree (MST) region configuration, use the revision
command. To return to the default settings, use the no form of this command.
Syntax Description
version
Command Default
Revision 0.
Command Modes
MST configuration mode
Command History
Release
4.0(0)N1(1a)
Usage Guidelines
Two or more switches with the same VLAN mapping and name are considered to be in different MST
regions if the configuration revision numbers are different.
Caution
Be careful when using the revision command to set the revision number of the MST region configuration
because a mistake can put the switch in a different region.
Examples
This example shows how to set the revision number of the MST region configuration:
switch(config)# spanning-tree mst configuration
switch(config-mst)# revision 5
Related Commands
Command
show spanning-tree
mst
Cisco Nexus 5000 Series Command Reference
2-44
revision version
no revision version
Revision number for the MST region configuration; the range of valid values
is from 0 to 65535.
Modification
This command was introduced.
Description
Displays information about the MST protocol.
Chapter 2
Ethernet Commands
OL-16599-01

Advertisement

Table of Contents
loading

Table of Contents