Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 159

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

Ethernet Commands

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

If interfaces are configured for the EtherChannel interface and a member port is removed from the

EtherChannel, the configuration of the EtherChannel interface is not propagated to the member ports.

Any configuration changes that you make in any of the compatibility parameters to the EtherChannel

interface are propagated to all interfaces within the same channel group as the EtherChannel (for

example, configuration changes are also propagated to the physical interfaces that are not part of the

EtherChannel but are part of the channel group).

This example shows how to add an interface to LACP channel group 5 in active mode:

switch(config)# interface ethernet 1/1

switch(config-if)# channel-group 5 mode active

Related Commands

show interface

port-channel

show port-channel

Displays information about the traffic on the specified EtherChannel

Displays LACP information.

Displays information on the EtherChannels.

channel-group (Ethernet)

Cisco Nexus 5000 Series Command Reference