Channel-Group (Ethernet) - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual
Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Release note (26 pages)
Table of Contents
Advertisement
Chapter 2
Ethernet Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
channel-group (Ethernet)
To assign and configure a physical interface to a EtherChannel, use the channel-group command. To
remove the channel group configuration from the interface, use the no form of this command.
Syntax Description
number
mode
active
on
passive
Command Default
None
Command Modes
Interface configuration mode
Command History
Release
4.0(0)N1(1a)
OL-16599-01
channel-group number [mode {active | on | passive}]
no channel-group [number]
Number of channel group. The number range is from 1 to 4096. Cisco
NX-OS creates the EtherChannel associated with this channel group if the
EtherChannel does not already exist.
(Optional) Specifies the EtherChannel mode of the interface.
Specifies that when you enable the Link Aggregation Control Protocol
(LACP), this command enables LACP on the specified interface. Interface is
in active negotiating state, in which the port initiates negotiations with other
ports by sending LACP packets.
This is the default channel mode. All EtherChannels that are not running
LACP remain in this mode. If you attempt to change the channel mode to
active or passive before enabling LACP, the switch returns an error message.
After you enable LACP globally, by using the
enable LACP on each channel by configuring the channel mode as either
active or passive. An interface in this mode does not initiate or respond to
LACP packets. When an LACP attempts to negotiate with an interface in the
on state, it does not receive any LACP packets and becomes an individual
link with that interface; it does not join the channel group.
The default mode is on.
Specifies that when you enable LACP, this command enables LACP only if
an LACP device is detected. The interface is in a passive negotiation state,
in which the port responds to LACP packets that it receives but does not
initiate LACP negotiation.
Modification
This command was introduced.
channel-group (Ethernet)
feature lacp
Cisco Nexus 5000 Series Command Reference
command, you
2-7
Advertisement
Table of Contents
