Match Cos (Class Map Type Qos) - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

match cos (class map type qos)

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
match cos (class map type qos)
To define the class of traffic using the Class of Service (CoS) value in a type qos class map, use the
match cos command. To remove the match on the CoS value, use the no form of this command.
Syntax Description
not
cos-list
Defaults None
Command Modes Class-map type qos configuration
Command History Release
4.1(3)N1(1)
Usage Guidelines To specify a list of values, use one of the following options:
•
•
Only class maps of type qos support the optional not keyword form of this command. Class maps of type
Note
queuing do not support the not keyword.
This command does not require a license.
Examples
This example shows how to match on the CoS value for a type qos class map:
switch(config)# class-map class_acl
switch(config-cmap-qos)# match cos 5-7
Related Commands Command
show class-map
Cisco Nexus 5000 Series Command Reference
5-4
match [not] cos cos-list
no match [not] cos cos-list
(Optional) Negates the specified match result.
Matches on the specified COS value or list of specified CoS values. Valid
values are from 0 to 7.
Modification
This command was introduced.
Specify a range of values separated by a dash
Specify a noncontiguous list of values separated by commas
Description
Displays class maps.
Chapter 5 Quality of Service Commands
OL-16599-01