Databits - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 1 Basic System Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

databits

To configure the number of data bits in a character for the terminal port, use the databits command. To
revert to the default, use the no form of this command.
Syntax Description
bits
Command Default 8 bits
Command Modes Terminal line configuration
Command History Release
4.0(0)N1(1a)
Usage Guidelines You can configure the console port only from a session on the console port.
Examples This example shows how to configure the number of data bits for the console port:
switch# configure terminal
switch(config)# line console
switch(config-console)# databits 7
This example shows how to revert to the default number of data bits for the console port:
switch# configure terminal
switch(config)# line console
switch(config-console)# no databits 7
Related Commands Command
show line
OL-16599-01
databits bits
no databits bits
Number of data bits in a character. The range is from 5 to 8.
Modification
This command was introduced.
Description
Displays information about the console port configuration.
Cisco Nexus 5000 Series Command Reference
databits
1-25