Enabling Or Disabling Fspf; Clearing Fspf Counters For The Vsan; Fspf Interface Configuration; About Fspf Link Cost - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring Fibre Channel Routing Services and Protocols
Procedure
Step 1
Step 2

Enabling or Disabling FSPF

To enable or disable FSPF routing protocols, perform this task:
Procedure
Step 1
Step 2
Step 3

Clearing FSPF Counters for the VSAN

To clear the FSPF statistics counters for the entire VSAN, perform this task:
Procedure
Step 1

FSPF Interface Configuration

Several FSPF commands are available on a per-interface basis. These configuration procedures apply to an
interface in a specific VSAN.

About FSPF Link Cost

FSPF tracks the state of links on all switches in the fabric, associates a cost with each link in its database, and
then chooses the path with a minimal cost. The cost associated with an interface can be administratively
changed to implement the FSPF route selection. The integer value to specify cost can range from 1 to 65,535.
The default cost for 1 Gbps is 1000 and for 2 Gbps is 500.
OL-16597-01
Command or Action
switch# configuration terminal
switch(config)# no fspf config vsan vsan-id
Command or Action
switch# configuration terminal
switch(config)# fspf enable vsan vsan-id
switch(config)# no fspf enable vsan vsan-id
Command or Action
switch# clear fspf counters vsan
vsan-id
Purpose
Enters configuration mode.
Deletes the FSPF configuration for the
specified VSAN.
Purpose
Enters configuration mode.
Enables the FSPF routing protocol in the
specified VSAN.
Disables the FSPF routing protocol in the
specified VSAN.
Purpose
Clears the FSPF statistics counters for the specified
VSAN. If an interface reference is not specified, all
counters are cleared.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Enabling or Disabling FSPF
581