Port-Track Enable - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

port-track enable

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
port-track enable
To enable port tracking for indirect errors, use the port-track enable command. To disable this feature,
use the no form of the command.
Syntax Description
This command has no other arguments or keywords.
Command Default Disabled.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines The software brings the linked port down when the tracked port goes down. When the tracked port
recovers from the failure and comes back up again, the tracked port is also brought up automatically
(unless otherwise configured).
Examples
The following example shows how to enable port tracking:
switch(config)# port-track enable
The following example shows how to disable port tracking:
switch(config)# no port-track enable
Related Commands Command
show interface fc
show interface
san-port-channel
Cisco Nexus 5000 Series Command Reference
8-116
port-track enable
no port-track enable
Modification
This command was introduced.
Description
Displays configuration and status information for a specified Fibre Channel
interface.
Displays configuration and status information for a specified SAN port
channel interface.
Chapter 8 Fibre Channel Commands
OL-16599-01