Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 762

show zone analysis
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Table 9-4
zoning database.
Table 9-4
Field
Last updated at
Last Updated by
Num zonesets
Num zones
Num aliases
Num attribute groups
Cisco Nexus 5000 Series Command Reference
9-54
describes the fields displayed in the output of a show zone analysis command for the full
show zone analysis Field Descriptions for the Full Zoning Database
Description
Displays a time stamp showing when the full zoning database was last
updated.
Displays the agent that most recently modified the full zoning database. The
agent can be one of the following three types:
Local: indicates that the full database was last modified locally through
•
a configuration change from one of the following applications:
CLI—The full zoning database was modified by the user from the
–
command line interface.
SNMP—The full zoning database was modified by the user through
–
the Simple Network Management Protocol (SNMP).
GS—The full zoning database was modified from the Generic
–
Services (GS) client.
CIM—The full zoning database was modified by the applications
–
using the Common Information Model (CIM).
INTERNAL—The full zoning database was modified as a result of
–
an internal activation either from Inter-VSAN Routing (IVR) or
from the IP storage services manager.
• Merge—Indicates that the full database was last modified by the Merge
protocol. In this case, the interface on which the merge occurred is also
displayed.
Remote—Indicates that the full database was last modified by the
•
Change protocol, initiated by a remote switch, when the full zone set
distribution was enabled. The domain, IP address, and switch name of
the switch initiating the change are also displayed.
The switch name is displayed on the next line, aligned with the
Note
domain, only if the switch name is set. The default switch name
switch and the ip-address are not displayed.
Displays the total number of zone sets in the database.
Displays the total number of zones in the database, including unassigned
zones.
Displays the total number of aliases in the database, including unassigned
FC aliases.
Displays the total number of attribute groups in the database. This field
applies only when enhanced zoning is used.
Chapter 9 Fibre Channel Show Commands
OL-16599-01