Logging Monitor - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 7 System Management Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

logging monitor

Use the logging monitor command to enable the device to log messages to the monitor (terminal line).
This configuration applies to Telnet and SSH sessions.
To disable monitor log messages, use the no form of this command.
Syntax Description
severity-level
Command Default None
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Examples This example shows how to enable monitor log messages:
switch(config)# logging monitor
Related Commands Command
show logging monitor
OL-16599-01
logging monitor [severity-level]
no logging monitor
(Optional) The number of the desired severity level at which messages
should be logged. Messages at or numerically lower than the specified level
are logged. Severity levels are as follows:
•
•
•
•
•
•
•
•
Modification
This command was introduced.
Description
Displays the status of monitor logging.
0—emergency: System unusable
1—alert: Immediate action needed
2—critical: Critical condition—default level
3—error: Error condition
4—warning: Warning condition
5—notification: Normal but significant condition
6—informational: Informational message only
7—debugging: Appears during debugging only
Cisco Nexus 5000 Series Command Reference
logging monitor
7-15