Show Loadbalancing - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 9 Fibre Channel Show Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

show loadbalancing

To display load-balancing status for specific unicast flows, use the show loadbalancing command.
Syntax Description
vsan vsan-id
source-fcid
dest-fcid
exchange-id
Command Default
None
Command Modes EXEC mode.
Command History Release
4.0(0)N1(1a)
Examples
The following example displays the load-balancing information for the specified source and destination
in VSAN 3:
switch# show loadbalancing vsan 3 0x3345 0x2546
OL-16599-01
show loadbalancing vsan vsan-id source-fcid dest-fcid [exchange-id]
Displays FLOGI database entries based on the FCID allocated. The format
is 0xhhhhhh.
Displays loadbalancing status for the specified source FCID. The format is
0xhhhhhh.
Displays loadbalancing status for the specified destination FCID. The format
is 0xhhhhhh.
(Optional) Displays loadbalancing status for the specified exchange. The
format is 0xhhhhhh.
Modification
This command was introduced.
Cisco Nexus 5000 Series Command Reference
show loadbalancing
9-33