Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 208

spanning-tree mst configuration
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
In the unlikely event that two administrators commit a new configuration at exactly the same time, this
warning message is displayed:
% MST CFG:Configuration change lost because of concurrent access
Examples
This example shows how to enter MST-configuration mode:
switch(config)# spanning-tree mst configuration
switch(config-mst)#
This example shows how to reset the MST configuration (name, instance mapping, and revision number)
to the default settings:
switch(config)# no spanning-tree mst configuration
Related Commands Command
instance vlan
name (MST
configuration)
revision
show spanning-tree
mst
Cisco Nexus 5000 Series Command Reference
2-58
Description
Maps a VLAN or a set of VLANs to an MST instance.
Sets the name of an MST region.
Sets the revision number for the MST configuration.
Displays the information about the MST protocol.
Chapter 2 Ethernet Commands
OL-16599-01