Ip Igmp Snooping (Vlan) - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

ip igmp snooping (VLAN)

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
ip igmp snooping (VLAN)
To configure Internet Group Management Protocol (IGMP) on a VLAN, use the ip igmp snooping
command. To negate the command or return to the default settings, use the no form of this command
Syntax Description
parameter
Command Default
The default settings are as follows:
•
•
•
•
•
Command Modes VLAN configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines The valid values for parameter are as follows:
Keyword and Argument
explicit-tracking
fast-leave
last-member-query-interval
seconds
mrouter interface interface
querier IP-address
Cisco Nexus 5000 Series Command Reference
2-24
ip igmp snooping parameter
no ip igmp snooping parameter
Parameter to configure. See the "Usage Guidelines" section for additional
information.
explicit-tracking—enabled
fast-leave—disabled for all VLANs
last-member-query-interval seconds—1
querier IP-address—disabled
report-suppression—enabled
Modification
This command was introduced.
Description
Enables tracking IGMPv3 membership reports for each port on a
per-VLAN basis. The default is enabled on all VLANs.
Enables IGMPv3 snooping fast-leave processing. The default is
disabled for all VLANs.
Removes the group if no hosts respond to an IGMP query message.
Valid value is from 1 to 25 seconds. The default is 1 second.
Configures a static connection to a multicast router. The specified
interface is Ethernet or EtherChannel.
Configures a snooping querier. The IP address is used as the source
in messages. The default is disabled.
Chapter 2 Ethernet Commands
OL-16599-01