Fspf Cost - Cisco MDS 9000 series Command Reference Manual

fspf cost

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
fspf cost
To configure FSPF link cost for an FCIP interface, use the fspf cost command. To revert to the default
value, use the no form of the command.
Syntax Description
link-cost
vsan vsan-id
Defaults 1000 seconds for 1 Gbps
500 seconds for 2 Gbps
Command Modes Interface configuration submode.
Command History Release
1.1(1)
Usage Guidelines
Access this command from the
FSPF tracks the state of links on all switches in the fabric, associates a cost with each link in its database,
and then chooses the path with a minimal cost. The cost associated with an interface can be changed
using the fspf cost command to implement the FSPF route selection.
Examples The following example configures the FSPF link cost on an FCIP interface.
switch# config terminal
switch(config)# interface fcip 1
switch(config-if)# fspf cost 5000 vsan 1
Related Commands Command
show fspf interface
show interface fcip
Cisco MDS 9000 Family Command Reference
8-76
fspf cost link-cost vsan vsan-id
no fspf cost link-cost vsan vsan-id
Modification
This command was introduced.
Description
Displays information for each selected interface.
Displays an interface configuration for a specified FCIP interface.
Enters FSPF link cost in seconds. The range is 1 to 65535.
Specifies a VSAN ID. The range is 1 to 4093.
submode.
switch(config-if)#
Chapter 8 F Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x