Interface Ethernet - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

interface ethernet

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
interface ethernet
To enter interface configuration mode for an Ethernet IEEE 802.3 interface, use the interface ethernet
command.
Syntax Description chassis_ID
slot
port
Command Default None
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
4.0(1a)N2(1)
Examples This example shows how to enter configuration mode for Ethernet interface 1/4:
switch(config)# interface ethernet 1/4
switch(config-if)#
This example shows how to enter configuration mode for a host interface on a Fabric Extender:
switch(config)# interface ethernet 101/1/1
switch(config-if)#
Related Commands Command
show fex
show interface
ethernet
Cisco Nexus 5000 Series Command Reference
2-20
interface ethernet [chassis_ID/]slot/port
(Optional) Specifies the Fabric Extender chassis ID. Chassis ID is 100 to
199.
Note
Specifies a slot from 1 to 3. The following list defines the slots available:
•
•
•
Specifies the port number within a particular slot.
Modification
This command was introduced.
This command was modified to provide the chassis ID argument.
Description
Displays all configured Fabric Extender chassis connected to the switch.
Displays various parameters of an Ethernet IEEE 802.3 interface.
This argument is not optional when addressing the host interfaces of
a Cisco Nexus 2000 Series Fabric Extender.
Slot 1 includes all the fixed ports. A Fabric Extender only has a Slot 1.
Slot 2 includes the ports on the upper expansion module (if populated).
Slot 3 includes the ports on the lower expansion module (if populated).
Chapter 2 Ethernet Commands
OL-16599-01