Wwn Secondary-Mac - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 8 Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

wwn secondary-mac

To allocate a secondary MAC address to a SAN node, use the wwn secondary-mac command.
Syntax Description
wwn-id
range address-range
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines This command cannot be undone.
Changes to the worldwide names are only performed as required. They should not be changed on a daily
basis. These changes should be made by an administrator or individual who is completely familiar with
switch operations.
For more information, refer to the Cisco Nexus 5000 Series CLI Configuration Guide.
Examples The following example allocates a secondary range of MAC addresses:
switch(config)# wwn secondary-mac 00:99:55:77:55:55 range 64
OL-16599-01
wwn secondary-mac wwn-id range address-range
The secondary MAC address with the format hh:hh:hh:hh:hh:hh.
The range for the specified WWN. The only valid value is 64.
Modification
This command was introduced.
Cisco Nexus 5000 Series Command Reference
wwn secondary-mac
8-143