Zone Commit - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

zone commit

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
zone commit
To commit zoning changes to a VSAN, use the zone commit command. To negate the command, use the
no form of the command.
Syntax Description
vsan vsan-id
force
Command Default None
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines Use the no form of the zone commit command to clear a session lock on a switch where the lock
originated.
Examples The following example commits zoning changes to VSAN 200:
switch(config)# zone commit vsan 200
Related Commands Command
show zone
Cisco Nexus 5000 Series Command Reference
8-146
zone commit vsan vsan-id [force]
no zone commit vsan vsan-id [force]
Specifies the VSAN ID. The range is 1 to 4093.
(Optional) Forces the commit.
Modification
This command was introduced.
Description
Displays zone information.
Chapter 8 Fibre Channel Commands
OL-16599-01