Tacacs-Server Timeout - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 6 Security Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

tacacs-server timeout

To specify the time between retransmissions to the TACACS+ servers, use the tacacs-server timeout
command. To revert to the default, use the no form of this command.
Syntax Description
seconds
Command Default
1 second.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines You must use the feature tacacs+ command before you configure TACACS+.
Examples This example shows how to configure the TACACS+ server timeout value:
switch(config)# tacacs-server timeout 3
This example shows how to revert to the default TACACS+ server timeout value:
switch(config)# no tacacs-server timeout 3
Related Commands Command
feature tacacs+
show tacacs-server
OL-16599-01
tacacs-server timeout seconds
no tacacs-server timeout seconds
Seconds between retransmissions to the TACACS+ server. The valid range
is 1 to 60 seconds.
Modification
This command was introduced.
Description
Enables TACACS+.
Displays TACACS+ server information.
Cisco Nexus 5000 Series Command Reference
tacacs-server timeout
6-139