Spanning-Tree Mst Cost - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 2 Ethernet Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

spanning-tree mst cost

To set the path-cost parameter for any Multiple Spanning Tree (MST) instance (including the common and
internal spanning tree [CIST] with instance ID 0) use the spanning-tree mst cost command. To return to
the default settings, use the no form of this command.
Syntax Description
instance-id
cost
auto
Command Default Automatically set port cost values:
•
•
•
•
Command Modes
Interface configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines
The port cost depends on the port speed; the faster interface speeds indicate smaller costs. MST always
uses long path costs.
Higher cost values indicate higher costs. When entering the cost, do not include a comma in the entry;
for example, enter 1000, not 1,000.
The EtherChannel bundle is considered a single port. The port cost is the aggregation of all the
configured port costs assigned to that channel.
Examples
This example shows how to set the interface path cost:
switch(config-if)# spanning-tree mst 0 cost 17031970
OL-16599-01
spanning-tree mst instance-id cost {cost | auto}
no spanning-tree mst instance-id cost
Instance ID number; the range of valid values is from 0 to 4094.
Port cost for an instance; the range of valid values is from 1 to 200,000,000.
Sets the value of the port cost by the media speed of the interface.
10 Mbps—2,000,000
100 Mbps—200,000
1-Gigabit Ethernet—20,000
10-Gigabit Ethernet—2,000
Modification
This command was introduced.
Cisco Nexus 5000 Series Command Reference
spanning-tree mst cost
2-59