Terminal Width - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

Basic System Commands

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

terminal width

To set the number of character columns on the terminal screen for the current line for a session, use the

terminal width command. To revert to the default, use the no form of this command.

Syntax Description

Command Default

For a virtual terminal, the width is set during negotiation with the client software. Otherwise, 80 columns

is the default.

Command Modes

Command History

4.0(0)N1(1a)

Usage Guidelines

The terminal width setting applies only to the current session.

This example shows how to set the number of columns to display on the terminal:

switch# terminal width 70

This example shows how to revert to the default number of columns:

switch# terminal no width

Related Commands

show terminal

terminal width columns

terminal no width

Number of columns. The range is from 24 to 511.

Modification

This command was introduced.

Displays the terminal session configuration.

Cisco Nexus 5000 Series Command Reference

terminal width

Do you have a question about the AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?