Lacp Port-Priority - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

lacp port-priority

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

lacp port-priority

To set the priority for the physical interfaces for the Link Aggregation Control Protocol (LACP), use the

lacp port-priority command. To return the port priority to the default value, use the no form of this

Syntax Description

Command Default

System priority value is 32768.

Command Modes

Interface configuration mode

Command History

4.0(0)N1(1a)

Usage Guidelines

Each port configured to use LACP has an LACP port priority. You can configure a value between 1 and

65535. LACP uses the port priority in combination with the port number to form the port identifier. The

port priority is used with the port number to form the port identifier. The port priority is used to decide

which ports should be put into standby mode when there is a hardware limitation that prevents all

compatible ports from aggregating.

When setting the priority, note that a higher number means a lower priority.

This example shows how to set the LACP port priority for the interface to 2000:

switch(config-if)# lacp port-priority 2000

Related Commands

Cisco Nexus 5000 Series Command Reference

lacp port-priority priority

no lacp port-priority

Priority for the physical interfaces. The range of valid numbers is from 1 to

Modification

This command was introduced.

Displays LACP information.

Ethernet Commands