Vlan Access-Map - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 6 Security Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

vlan access-map

To create a new VLAN access map or to configure an existing VLAN access map, use the vlan
access-map command. To remove a VLAN access map, use the no form of this command.
Syntax Description
map-name
Command Default None
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines Each VLAN access map can include one match command and one action command.
Examples This example shows how to create a VLAN access map named vlan-map-01, assign an IPv4 ACL named
ip-acl-01 to the map, specify that the switch forwards packets matching the ACL, and enable statistics
for traffic matching the map:
switch(config)# vlan access-map vlan-map-01
switch(config-access-map)# match ip address ip-acl-01
switch(config-access-map)# action forward
switch(config-access-map)# statistics
Related Commands Command
action
match
show vlan access-map
show vlan filter
vlan filter
OL-16599-01
vlan access-map map-name
no vlan access-map map-name
Name of the VLAN access map that you want to create or configure.
Modification
This command was introduced.
Description
Specifies an action for traffic filtering in a VLAN access map.
Specifies an ACL for traffic filtering in a VLAN access map.
Displays all VLAN access maps or a VLAN access map.
Displays information about how a VLAN access map is applied.
Applies a VLAN access map to one or more VLANs.
Cisco Nexus 5000 Series Command Reference
vlan access-map
6-147