Exec-Timeout - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

exec-timeout

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
exec-timeout
To configure the inactive session timeout on the console port or the virtual terminal, use the
exec-timeout command. To revert to the default, use the no form of this command.
Syntax Description
minutes
Command Default
Timeout is disabled.
Command Modes Terminal line configuration
Command History Release
4.0(0)N1(1a)
Usage Guidelines You can configure the console port only from a session on the console port.
Examples This example shows how to configure the inactive session timeout for the console port:
switch# configure terminal
switch(config)# line console
switch(config-console)# exec-timeout 30
This example shows how to revert to the default inactive session timeout for the console port:
switch# configure terminal
switch(config)# line console
switch(config-console)# no exec-timeout
This example shows how to configure the inactive session timeout for the virtual terminal:
switch# configure terminal
switch(config)# line vty
switch(config-line)# exec-timeout 30
This example shows how to revert to the default inactive session timeout for the virtual terminal:
switch# configure terminal
switch(config)# line vty
switch(config-line)# no exec-timeout
Cisco Nexus 5000 Series Command Reference
1-34
exec-timeout minutes
no exec-timeout
Number of minutes. The range is from 0 to 525600. A setting of 0 minutes
disables the timeout.
Modification
This command was introduced.
Chapter 1 Basic System Commands
OL-16599-01