Clear Mac-Address-Table Dynamic - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual
Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Release note (26 pages)
Table of Contents
Advertisement
clear mac-address-table dynamic
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
clear mac-address-table dynamic
To clear the dynamic address entries from the MAC address table, use the clear mac-address-table
dynamic command.
Syntax Description
address mac-addr
interface type slot/port (Optional) Specifies the interface for which MAC addresses should be
port-channel number
vlan vlan-id
Command Default
None
Command Modes
EXEC mode
Command History
Release
4.0(0)N1(1a)
Usage Guidelines
Use the clear mac-address-table dynamic command with no arguments to remove all dynamic entries
from the table.
To clear static MAC addresses from the table, use the no mac-address-table static command.
If the clear mac-address-table dynamic command is entered with no options, all dynamic addresses
are removed. If you specify an address but do not specify an interface, the address is deleted from all
interfaces. If you specify an interface but do not specify an address, the switch removes all addresses on
the specified interfaces.
Examples
This example shows how to clear all the dynamic entries from the MAC address table:
switch# clear mac-address-table dynamic
This example shows how to clear all the dynamic entries from the MAC address table for VLAN 2:
switch# clear mac-address-table dynamic vlan 2
Cisco Nexus 5000 Series Command Reference
2-12
clear mac-address-table dynamic [[address mac-addr] | [interface {type slot/port | port-channel
number}]] [vlan vlan-id]
(Optional) Specifies the MAC address to remove from the table. Use the
format EEEE.EEEE.EEEE.
removed from the table. The type can be either ethernet. Specify the
appropriate slot or virtual interface group number and port number.
(Optional) Specifies the EtherChannel for which MAC addresses should be
removed from the table. Use the EtherChannel number.
(Optional) Specifies the VLAN from which MAC addresses should be
removed from the table. The range of valid values is from 1 to 4094.
Modification
This command was introduced.
Chapter 2
Ethernet Commands
OL-16599-01
Advertisement
Table of Contents
