Radius-Server Timeout - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

radius-server timeout

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
radius-server timeout
To specify the time between retransmissions to the RADIUS servers, use the radius-server timeout
command. To revert to the default, use the no form of this command.
Syntax Description
seconds
Command Default
1 second.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Examples This example shows how to configure the timeout interval:
switch(config)# radius-server timeout 30
This example shows how to revert to the default interval:
switch(config)# no radius-server timeout 30
Related Commands Command
show radius-server
Cisco Nexus 5000 Series Command Reference
6-86
radius-server timeout seconds
no radius-server timeout seconds
Number of seconds between retransmissions to the RADIUS server. The
range is from 1 to 60 seconds.
Modification
This command was introduced.
Description
Displays RADIUS server information.
Chapter 6 Security Commands
OL-16599-01