FSPF Interface Configuration
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
•
•
•
•
•
About FSPF Link Cost
FSPF tracks the state of links on all switches in the fabric, associates a cost with each link in its database,
and then chooses the path with a minimal cost. The cost associated with an interface can be
administratively changed to implement the FSPF route selection. The integer value to specify cost can
range from 1 to 65,535. The default cost for 1 Gbps is 1000 and for 2 Gbps is 500.
Configuring FSPF Link Cost
To configure FSPF link cost, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# interface fc slot/port
Step 3
switch(config-if)# fspf cost value vsan
vsan-id
About Hello Time Intervals
You can set the FSPF Hello time interval to specify the interval between the periodic hello messages sent
to verify the health of the link. The integer value can range from 1 to 65,535 seconds.
This value must be the same in the ports at both ends of the ISL.
Note
Configuring Hello Time Intervals
To configure the FSPF Hello time interval, perform this task:
Command
Step 1
switch# configuration terminal
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
40-6
About Retransmitting Intervals, page 40-7
Configuring Retransmitting Intervals, page 40-8
About Disabling FSPF for Specific Interfaces, page 40-8
Disabling FSPF for Specific Interfaces, page 40-8
Clearing FSPF Counters for an Interface, page 40-9
Chapter 40
Configuring Fibre Channel Routing Services and Protocols
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the
specified interface.
Configures the cost for the selected interface in the
specified VSAN.
Purpose
Enters configuration mode.
OL-16597-01