Show Lacp - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

show lacp

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show lacp
To display Link Aggregation Control Protocol (LACP) information, use the show lacp command.
Syntax Description counters
interface ethernet
slot/port
neighbor [interface
port-channel number]
port-channel
[interface
port-channel number]
system-identifier
Command Default
None
Command Modes
EXEC mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines
Use the show lacp command to troubleshoot problems related to LACP in a network.
Examples
This example shows how to display the LACP system identification:
switch# show lacp system-identifier
Cisco Nexus 5000 Series Command Reference
3-8
show lacp {counters | interface ethernet slot/port | neighbor [interface port-channel number] |
port-channel [interface port-channel number] | system-identifier}
Displays information about the LACP traffic statistics.
Displays LACP information for a specific interface.
Displays information about the LACP neighbor. Optionally provide an
EtherChannel number.
Displays information about an EtherChannel. Optionally provide an
EtherChannel number.
Displays the LACP system identification. It is a combination of the port
priority and the MAC address of the device
Modification
This command was introduced.
Chapter 3 Ethernet Show Commands
OL-16599-01