Show Interface Vlan - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 3 Ethernet Show Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

show interface vlan

To display brief descriptive information about specified VLANs, use the show interface vlan command.
Syntax Description
vlan-id
brief
description
private-vlan mapping
Command Default None
Command Modes
EXEC mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines You must enable interface VLANs by using the
commands for configuring interface VLANs are not visible until you enable this feature.
This command displays descriptive information for the specified VLAN, including private VLANs.
The switch displays output for the show interface vlan vlan-id private-vlan mapping command only
when you specify a primary private VLAN. If you specify a secondary private VLAN, the output is
blank.
Examples This example shows how to display information about the specified VLAN:
switch# show interface vlan 5
This example shows how to display a brief description for the specified VLAN:
switch# show interface vlan 5 brief
This example shows how to display the description for a specified VLAN:
switch# show interface vlan 5 description
This example shows how to display the private VLAN mapping information, if any, for the VLAN:
switch# show interface vlan 5 private-vlan mapping
When you specify a primary VLAN, the switch displays all secondary VLANs mapped to that primary
VLAN.
OL-16599-01
show interface vlan vlan-id [brief | description | private-vlan mapping]
Number of the VLAN; the range of valid values is from 1 to 4094.
(Optional) Summary information for the specified VLAN.
(Optional) Description of the specified VLAN.
(Optional) Private VLAN mapping information, if any, for the specified
VLAN.
Modification
This command was introduced.
feature interface-vlan or the
Cisco Nexus 5000 Series Command Reference
show interface vlan
svi enable command. The
3-5