Show Vpc Statistics - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

show vpc statistics

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show vpc statistics
To display virtual port-channel (vPC) statistics, use the show vpc statistics command.
Syntax Description[
peer-keepalive
peer-link
vpc number
Defaults None
Command Modes Any command mode.
Command History Release
4.1(3)N1(1)
Usage Guidelines The peer-link parameter displays the same information as the show interface port-channel channel
number command for the vPC peer-link port channel.
The vpc number parameter displays the same information as the show interface port-channel channel
number command for the specified vPC port channel.
This command is not available if you have not enabled the vPC feature. See feature vpc for information
on enabling vPCs.
This command does not require a license.
Examples This example shows how to display statistics about the peer-keepalive message:
switch# show vpc statistics peer-keepalive
vPC keep-alive status
VPC keep-alive statistics
----------------------------------------------------
peer-keepalive tx count:
peer-keepalive rx count:
average interval for peer rx:
Count of peer state changes:
Cisco Nexus 5000 Series Command Reference
10-18
show vpc statistics {peer-keepalive | peer-link | vpc number}
Displays statistics about the peer-keepalive message.
Displays statistics about the peer link.
Displays statistics about the specified vPC. The range is from 1 to
4096.
Modification
This command was introduced.
: peer is alive
1036
1028
995
1
Chapter 10 Vpc Commands
OL-16599-01