radius-server deadtime
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
radius-server deadtime
To configure the dead-time interval for all RADIUS servers on a Cisco Nexus 5000 Series switch, use
the radius-server deadtime command. To revert to the default, use the no form of this command.
Syntax Description
minutes
Command Default
0 minutes.
Command Modes
Configuration mode
Command History
Release
4.0(0)N1(1a)
Usage Guidelines
The dead-time interval is the number of minutes before the switch checks a RADIUS server that was
previously unresponsive.
When the idle time interval is 0 minutes, periodic RADIUS server monitoring is not performed.
Note
Examples
This example shows how to configure the global dead-time interval for all RADIUS servers to perform
periodic monitoring:
switch(config)# radius-server deadtime 5
This example shows how to revert to the default for the global dead-time interval for all RADIUS servers
and disable periodic server monitoring:
switch(config)# no radius-server deadtime 5
Related Commands
Command
show radius-server
Cisco Nexus 5000 Series Command Reference
6-80
radius-server deadtime minutes
no radius-server deadtime minutes
Number of minutes for the dead-time interval. The range is from 1 to 1440
minutes.
Modification
This command was introduced.
Description
Displays RADIUS server information.
Chapter 6
Security Commands
OL-16599-01