Radius-Server Retransmit - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

Security Commands

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

radius-server retransmit

To specify the number of times that the switch should try a request with a RADIUS server, use the

radius-server retransmit command. To revert to the default, use the no form of this command.

Syntax Description

Command Default

1 retransmission.

Command Modes

Configuration mode

Command History

4.0(0)N1(1a)

This example shows how to configure the number of retransmissions to RADIUS servers:

switch(config)# radius-server retransmit 3

This example shows how to revert to the default number of retransmissions to RADIUS servers:

switch(config)# no radius-server retransmit 3

Related Commands

show radius-server

radius-server retransmit count

no radius-server retransmit count

Number of times that the switch tries to connect to a RADIUS server before

reverting to local authentication. The range is from 1 to 5 times.

Modification

This command was introduced.

Displays RADIUS server information.

Cisco Nexus 5000 Series Command Reference

radius-server retransmit